Io = 2.64A at 10V
Kv = 980 rpm/volt
R = 0.025 Ohms
Length = 43.9mm
Diameter = 37.5mm
Weight = 191g
Continuous current accepted = 68A
Maximum continuous power = 1000W
Shaft = 5mm carbonised steel (protrudes both ends)
Collet-type prop adaptor and back-mount supplied
Motor fixing = four 3mm bolts supplied
Male bullet connectors fitted to motor
Female bullet connectors supplied
|An LRK (outrunner) brushless motor for R/C aircraft up to 3.5 kg powered by 7-16 cells or 2-5S LiPo; suitable for cabin models, scale models, aerobatic models and gliders - this motor would work well in competition gliders with a large prop - use the 110A speed controller if you are going to push this motor. No gearbox is required because of the high torque of this motor type.
All Scorpion 30mm motors have 3 ball bearings to support the rotating housing.
The S30 series of motors from Scorpion all have 30mm diameter stators - there are 12 stator arms and 14 magnets in the rotor housing. The stator is 26mm long in this 3026 version. The motor wind is a 10 turn delta wind with 24 strand 0.21mm wire.
Prop for 2S - 16x10"
Motor guaranteed for two years
No longer available
|Motors that compare to the Scorpion 3026-10:
Atlas 2927/08, 910 KV
Axi 2826/10, 920 KV
Dualsky XM4250CA-5, 1020 KV
Hacker A30-10XL, 900 KV
Hyperion Z3025-8, 985 KV
HXT 35-48B, 900 KV
Thunder Tiger OBL36/09-46A, 910 KV
* Actual test by David Morgan using an Emeter - AN folders draw more amps than APC-E for the same size and give more thrust - posted 15-4-08.
Click here for a more extensive Prop Data chart for the Scorpion 3026-10.